Chapter 4 Settings — [DISPLAY OPTION] menuENGLISH - 115[ON] Displays the waveform monitor.3) Press the 4) Press as to select any horizontal line.5) Press the button to switch the Select line to either luminance, red, green, or blue.f Line selection items switch each time the is pressed only when the waveform monitor isdisplayed.“Select line (luminance)” Displayed in white waveform.“Select line (red)” Displayed in red waveform.“Select line (green)” Displayed in green waveform.“Select line (blue)” Displayed in blue waveform.Notef Setting is also available from the [PROJECTOR SETUP] menu → [FUNCTION BUTTON].f The waveform monitor cannot be displayed while in the P IN P mode.f The waveform monitor turns off when the P IN P function is used while the waveform is being monitored.f The waveform monitor is not displayed when on-screen display is hidden (off).Adjusting the waveformProject the luminance adjustment signal of a commercial test disk (0 % (0 IRE or 7.5 IRE) – 100 % (100 IRE)) andadjust.Signal levelImage displayable areaImage position1) Select “Select line (luminance)” on the waveform monitor.2) Adjust black level.f Adjust the black level 0 % of the video signal to the 0 % position of the waveform monitor using the[PICTURE] menu → [BRIGHTNESS].3) Adjust white level.f Adjust the white level 100 % of the video signal to the 100 % position of the waveform monitor using the[PICTURE] menu → [CONTRAST].Adjusting red, green, and blue1) Set [COLOR TEMPERATURE] to [USER1] or [USER2]. (x page 80)2) Select “Select line (red)” on the waveform monitor.3) Adjust dark red areas.f Use [RED] in [WHITE BALANCE LOW] to adjust the black level 0 % of the video signal to the 0 % positionof the waveform monitor.4) Adjust bright red areas.f Use [RED] in [WHITE BALANCE HIGH] to adjust the white level 100 % of the video signal to the 100 %position of the waveform monitor.5) Use the procedure for [RED] to adjust [GREEN] and [BLUE].
