Panasonic PT-RW730 Operating Instructions Manual

Also see for PT-RW620: Operating instructions Operating instructions Operating instructions

Contents

Chapter 1 Preparation — Precautions for use18 - ENGLISHrBe sure to ask a specialized technician or your dealer when installing the projector ona ceiling.The optional Ceiling Mount Bracket is required.Model No.: ET-PKD120H (for High Ceilings), ET-PKD120S (for Low Ceilings), ET-PKD130H (for High Ceilings,6-axis Adjustment), ET-PKD130B (Projector Mount Bracket)rAsk a qualified technician or your dealer to install the cable wiring for DIGITAL LINKconnection.Image and sound may be disrupted if cable transmission characteristics cannot be obtained due to inadequateinstallation.rThe projector may not work properly due to strong radio wave from the broadcaststation or the radio.If there is any facility or equipment which outputs strong radio waves near the installation location, install theprojector at a location sufficiently far from the source of the radio waves. Or, wrap the LAN cable connected to the terminal using a piece of metal foil or a metal pipe which is grounded at both ends.rFocus adjustmentThe high clarity projection lens is thermally affected by the light from the light source, making the focus unstable inthe period just after switching on the power. It is recommended that images be projected continuously for at least30 minutes before the focus is adjusted.rDo not install the projector at an altitude of 4 200 m (13 780') or higher above sea level.rDo not use the projector in a location that the ambient temperature exceeds 45 °C(113 °F).Using the projector in a location that the altitude is too high or the ambient temperature is too high may reduce thelife of the components or result in malfunctions.rProjection in all 360° direction is possible.360°360°360°360° vertically 360° horizontally 360° tilted(combination of vertical and horizontal)rThe geometric adjustment function is disabled when projecting the input signalrotated by 90°. (Only for PT‑RW730, PT‑RW620)The geometric adjustment function cannot be used when projecting the input signal rotated by 90°. Wheninstalling the projector, follow the following instructions to prevent distortion in the projected image.f Use a flat screen.f Install the projector so that the front side of the projector is parallel to the screen.f Install the projector so that the image can be projected within the range of shift adjustment by moving the lensposition.The 90° rotation of the image can be set in the [DISPLAY OPTION] menu → [IMAGE ROTATION].