Chapter 4 Settings — [PROJECTOR SETUP] menuENGLISH - 1318) Press asqw to select [COMMAND].9) Press the button.f The [COMMAND] detailed screen is displayed.10) Press as to select a [COMMAND].f For [COMMAND] which requires detailed settings, the items of the detailed settings will switch each timeyou press qw.f When [INPUT] is selected, press the button, and then press asqw to select the input to beset.[COMMAND] Detailed settings of[COMMAND] Description[POWER ON] ― Switches on the projector.[STANDBY] ― Enters standby.[QUICK STARTUP][ON] Enables the function of the [PROJECTOR SETUP] menu →[QUICK STARTUP].[OFF] Disables the function of the [PROJECTOR SETUP] menu →[QUICK STARTUP].[SHUTTER] [OPEN] Disables the shutter function (shutter: open).[CLOSE] Enables the shutter function (shutter: closed).[INPUT][RGB1] Switches the input to RGB1.[RGB2] Switches the input to RGB2.[DVI-D] Switches the input to DVI-D.[HDMI] Switches the input to HDMI.[DIGITAL LINK] Switches the input to DIGITAL LINK.[SDI] *1 Switches the input to SDI.[INPUT1] - [INPUT10] *2 Switches the input to DIGITAL LINK, and switches the input of thePanasonic twisted-pair-cable transmitter to the specified input.[OPERATING MODE]*3[NORMAL] Prioritizes luminance.[ECO] Controls the power to increase the life of the light source with higherluminance.[LONG LIFE1] Controls the power to increase the life of the light source althoughthe luminance is lower than that of [ECO].[LONG LIFE2] Controls the power to increase the life of the light source althoughthe luminance is even lower than that of [LONG LIFE1].[LONG LIFE3]Controls the power to increase the life of the light source to themaximum although the luminance is even lower than that of [LONGLIFE2].[USER1] Controls the power with the setting set in [USER1].[USER2] Controls the power with the setting set in [USER2].[USER3] Controls the power with the setting set in [USER3].[P IN P][OFF] P IN P function is not used.[USER1] Places the sub screen with the setting set in [USER1].[USER2] Places the sub screen with the setting set in [USER2].[USER3] Places the sub screen with the setting set in [USER3].*1 Only for PT-RZ770, PT-RZ660*2 When the optional DIGITAL LINK output supported device (Model No.: ET-YFB100G, ET-YFB200G) is connected to the projector, its inputname is automatically reflected from [INPUT1] to [INPUT10]. When an item that does not reflect the input name is selected, it will be disabled.*3 If you change the settings while using the projector, the duration until the luminance of light source decreases by half may shorten or theluminance may decrease.11) Press the button.f The command is fixed and n is displayed at the left of the selected command.f After the command is fixed, press the 12) Press asqw to select [STORE], and press the button.Notef To delete a command that has been already set, press the button on the remote control while the screen in Step 5) isdisplayed, or select [DELETE] at the screen in Step 6) and press the button.f If multiple commands have been set for the same time, they are executed in chronological order starting from the smallest commandnumber.f The operating time will be the local time. (x page 129)
