Chapter 4 Settings — [PROJECTOR SETUP] menu136 - ENGLISH[LENS CALIBRATION]Detect the lens shift limit value of the projector and set the home position and the ET-DLE030 lens standardposition automatically.1) Press as to select [LENS CALIBRATION].2) Press qw to switch the item.f The items will switch each time you press the button.[NORMAL] Select this item when anything other than the Fixed-focus Lens (Model No.: ET-DLE030) is used.Move the lens to the home position after completing the calibration.[DLE030] Select this item when the Fixed-focus Lens (Model No.: ET-DLE030) is used.Move the lens to the ET-DLE030 lens standard position after completing the calibration.3) Press the button.f The confirmation screen is displayed.4) Press qw to select [OK], and press the button.f To cancel, select [CANCEL].f The lens moves up, down, left, and right to detect the lens shift limit value, and automatically set the homeposition and the ET-DLE030 lens standard position.f The lens stops to complete the calibration.Notef [PROGRESS] is displayed in the menu during lens calibration. The operation cannot be canceled during calibration.f When lens calibration executes correctly, [COMPLETE] is displayed and [INCOMPLETE] is displayed when it does not execute correctly.f Pressing the button on the remote control for at least three seconds will also display the confirmation screen for lens calibrationexecution.[STATUS]Display the status of the projector.1) Press as to select [STATUS].2) Press the button.f The [STATUS] screen is displayed.3) Press qw to switch the pages.f The page will change each time you press the button.[PROJECTOR TYPE] Displays the projector type and serial number of the projector.[PROJECTOR RUNTIME] Displays the runtime of the projector.[LIGHT RUNTIME] Displays the runtime of the light source 1 and the light source 2.[MAIN/SUB VERSION] Displays the main and sub versions of the firmware of the projector.[INTAKE AIR TEMP.]*1 Displays the status of the intake air temperature of the projector.[OPTICS MODULE TEMP.] *1 Displays the status of the internal temperature of the projector.[EXHAUST AIR TEMP.]*1 Displays the status of the exhaust air temperature of the projector.[LIGHT1 TEMP.] *1 Displays the light source 1 temperature status of the projector.[LIGHT2 TEMP.] *1 Displays the light source 2 temperature status of the projector.[COOLING CONDITION] Displays the set cooling conditions.[ATMOSPHERIC PRESSURE] Displays the atmospheric pressure.[SELF TEST] Displays the status of the projector.[INPUT] Displays the input terminal currently selected.[SIGNAL NAME] Displays the input signal name.[MEMORY NO.] Displays the memory number of the input signal.[BACKUP INPUT STATUS] Displays whether switching to the backup input signal is possible or not when [BACKUP INPUTMODE] is set to [OFF]. (x page 101)[NUMBER OF REGISTEREDSIGNAL] Displays the number of registered signals.[ON COUNT] [POWER ON TIMES] Displays the number of times the power is turned on.[REMOTE2 STATUS] Displays the control status of the REMOTE2.[AC VOLTAGE] Displays the input supply voltage.
