| 
Chapter 3 Basic Operations — Operating with the remote controlENGLISH - 71Using the automatic setup functionThe image position when the DVI-D/HDMI signal is input, or the resolution, clock phase, and image position whenthe analog RGB signal is input can be adjusted automatically. (Analog RGB signal is a signal structured with dotsjust like the computer signal.)It is recommended to input an image with bright white borders at the edges and high-contrast black and whitecharacters when the automatic adjustment is being performed.Avoid using images that include halftones or gradation, such as photographs and computer graphics.button1) Press the button.f [COMPLETE] is displayed when it has completed without any problem.f This operation can be also performed by pressing the button on the control panel.Notef The clock phase may shift even if it has completed without any incident. In such a case, adjust the [POSITION] menu → [CLOCK PHASE](x page 89).f If an image with blurred edges or a dark image is input, [INCOMPLETE] may appear or adjustment may not be performed properly evenwhen [COMPLETE] appears. In such a case, adjust the following settings.g [ADVANCED MENU] menu → [INPUT RESOLUTION] (x page 93)g [POSITION] menu → [CLOCK PHASE] (x page 89)g [POSITION] menu → [SHIFT] (x page 87)f Adjust special signals according to the [DISPLAY OPTION] menu → [AUTO SETUP] (x page 100).f Automatic adjustment may not be possible depending on the computer model.f Automatic adjustment may not be possible for the synchronization signal for composite sync or SYNC ON GREEN.f Image may be disrupted for a few seconds during automatic adjustment, but this is not a malfunction.f Adjustment is required for each input signal.f Automatic adjustment can be canceled by pressing the f Even if a signal possible to perform the automatic setup is being input, it may not be able to adjust correctly if the automatic setup functionis used while the moving image is being input. [INCOMPLETE] may be displayed, or the adjustment may not be completed correctly even if[COMPLETE] is displayed.Using the function buttonBy assigning the following functions to the button, it can be used as a simplified shortcut button.[P IN P], [SUB MEMORY], [SYSTEM SELECTOR], [SYSTEM DAYLIGHT VIEW], [FREEZE], [WAVEFORMMONITOR], [ASPECT], [PROJECTION METHOD]button1) Press the button.Notef Assignment of the function is performed from the [PROJECTOR SETUP] menu → [FUNCTION BUTTON] (x page 135).Displaying internal test patternThe projector has eight types of internal test patterns to check the condition of the projector body. To display testpatterns, perform the following steps.button1) Press the button.2) Press qw to select the test pattern.Notef Test patterns can also be displayed using the menu operation. Refer to “[TEST PATTERN] menu” (x page 141) for details.f Settings of position, size, and other factors will not be reflected in test patterns. Make sure to display the input signal before performingvarious adjustments. |
