Chapter 4 Settings — [PROJECTOR SETUP] menuENGLISH - 133g All the projectors to be linked are connected in a loop with the daisy chain connection. (Maximum 64 projectors)g [MODE] on only one projector that is linked is set to [MASTER], and [MODE] on all other projectors are set to [SLAVE].g [CONTRAST SYNC] on the projectors to perform the contrast synchronization is set to [ON].f It is possible to set [CONTRAST SYNC] to [OFF] for the projectors that are linked but not to synchronize.Setting the shutter synchronization function1) Press as to select [MULTI PROJECTOR SYNC].2) Press the button.f The [MULTI PROJECTOR SYNC] screen is displayed.3) Press as to select [MODE].4) Press qw to switch the item.f The items will switch each time you press the button.[OFF] Select this item when the contrast synchronization function and the shutter synchronization functionare not used.[MASTER]Select this item when the contrast synchronization function or the shutter synchronization function isused.Set this item only on one projector that becomes the synchronization source of the shutter operation.[SLAVE]Select this item when the contrast synchronization function or the shutter synchronization function isused.Set this item in all the linked projectors excluding the projector set as the [MASTER].f When anything other than [OFF] is selected, the diagnostic result is displayed in [LINK STATUS], indicatingif all the projectors including the projectors targeted for synchronization are correctly connected, and if[MODE] is correctly set.[LINKED] All the projectors are correctly connected, and correctly set. They are in the condition that the contrastsynchronization function or the shutter synchronization function can be used.[NO LINK] The projectors are not correctly connected, or not correctly set. Check the cable connection statusand the projector setting for each projector that is linked.5) Press as to select [SHUTTER SYNC].6) Press qw to switch the item.f The items will switch each time you press the button.[OFF] Select this item when the shutter synchronization function is not used.[ON] Select this item when the shutter synchronization function is used.Notef The shutter synchronization function will operate when all of the following conditions are fulfilled.g All the projectors to be linked are connected in a loop with the daisy chain connection. (Maximum 64 projectors)g [MODE] on only one projector that is linked is set to [MASTER], and [MODE] on all other projectors are set to [SLAVE].g [SHUTTER SYNC] on the projectors to perform the shutter synchronization is set to [ON].f It is possible to set [SHUTTER SYNC] to [OFF] for the projectors that are linked but not to synchronize.f The shutter operation by the shutter synchronization function will follow the setting of the [DISPLAY OPTION] menu → [SHUTTERSETTING] on the projector that [MODE] is set to [MASTER].f When the input signal to each linked projector is not synchronized, the timing of the shutter operation between the projectors may shift up to1 frame while using the shutter synchronization function.f The shutter function of the projector with [MODE] set to [SLAVE] can be operated individually. At that time, the shutter operation will followthe setting of the [DISPLAY OPTION] menu → [SHUTTER SETTING] set in that projector.[RS-232C]Set the communication conditions of the /PROJECTOR SYNC OUT> terminals. For details on the connection method for RS-232C communication,refer to “/ terminals”(x page 191).Setting the communication condition of the terminal1) Press as to select [RS-232C].
