Chapter 4 Settings — [PROJECTOR SETUP] menuENGLISH - 1092) Press the button.f The [STATUS] screen is displayed.3) Press qw to switch the pages.f The page will change each time you press the button.[PROJECTOR TYPE] Displays the projector type and serial number of the projector.[PROJECTOR RUNTIME] Displays the runtime of the projector.[LIGHT RUNTIME] Displays the runtime of the light source.[MAIN/SUB VERSION] Displays the main and sub versions of the firmware of the projector.[INTAKE AIR TEMP.]*1 Displays the status of the intake air temperature of the projector.[OPTICS MODULE TEMP.] *1 Displays the status of the internal temperature of the projector.[EXHAUST AIR TEMP.]*1 Displays the status of the exhaust air temperature of the projector.[LIGHT TEMP. 1] *1 Displays the temperature status for the front block of the light source (on the lens side).[LIGHT TEMP. 2] *1 Displays the temperature status for the rear block of the light source (on the air exhaust port side).[COOLING CONDITION] Displays the set cooling conditions.[ATMOSPHERIC PRESSURE] Displays the atmospheric pressure.[SELF TEST] Displays the status of the projector.[INPUT] Displays the input terminal currently selected.[SIGNAL NAME] Displays the input signal name.[MEMORY NO.] Displays the memory number of the input signal.[ON COUNT] [POWER ON TIMES] Displays the number of times the power is turned on.[NUMBER OF REGISTEREDSIGNAL] Displays the number of registered signals.[SIGNAL INFORMATION][INPUT] Displays the input terminal used for the projected image.[SIGNAL NAME] Displays the input signal name.[SIGNAL FREQUENCY] Displays the frequency of the input signal.[SYNC.STATE] Displays the sync polarity of the input signal.[V.SYNC WIDTH] Displays the vertical sync signal pulse width of the input signal.[SCAN TYPE] Displays the scan type of the input signal.[TOTAL DOTS] Displays the total dot count of the input signal.[DISPLAY DOTS] Displays the number of input signal display dots.[TOTAL LINES] Displays the total line count of the input signal.[DISPLAY LINES] Displays the number of input signal display lines.[SAMPLING] Displays the sampling information of the input signal.[SIGNAL LEVEL] Displays the signal level of the input signal.*1 The temperature status is indicated with text color (green/yellow/red) and bar scale. Use the projector within the range that the indication isgreen.Notef E-mail containing the status can be sent to the E-mail address (up to two addresses) set in “[E-mail set up] page” (x page 139) bypressing the button while the [STATUS] screen is displayed.f There may be items that are displayed and items that are not displayed in [SIGNAL INFORMATION] depending on the setting or the inputsignal.f If any abnormality has occurred on the projector, press the button while the [STATUS] screen is displayed to display the detailscreen of the error information.f For details on the contents displayed in [SELF TEST], refer to “[SELF TEST] indications” (x page 153).[DATE AND TIME]Set the time zone, date, and time of the built-in clock of the projector.Setting the time zone1) Press as to select [DATE AND TIME].2) Press the button.f The [DATE AND TIME] screen is displayed.3) Press as to select [TIME ZONE].4) Press qw to switch [TIME ZONE].
