Chapter 4 Settings — [PROJECTOR SETUP] menuENGLISH - 1112) Press the button.f The [SECURITY PASSWORD] screen is displayed.3) Enter a security password and press the button.4) When the confirmation screen is displayed, press qw to select [OK], and press the button.Notef The projector enters the standby mode to reflect the setting values when [LOAD ALL USER DATA] is executed.f Data registered from a computer is not included in [ALL USER DATA].[INITIALIZE]Return various setting values to their factory default settings.1) Press as to select [INITIALIZE].2) Press the button.f The [SECURITY PASSWORD] screen is displayed.3) Enter a security password and press the button.f The [INITIALIZE] screen is displayed.4) Press as to select an item to initialize.[ALL USER DATA]Returns all setting values including [REGISTERED SIGNAL], [NETWORK/E-MAIL], and [LOGOIMAGE] to the factory default settings.The projector enters the standby mode to reflect the setting values.[REGISTERED SIGNAL]Deletes all the setting values saved for each input signal.To delete only a part of a registered signal, perform the procedure described in “Deleting theregistered signal” (x page 115).[NETWORK/E-MAIL] Returns the setting of the [NETWORK] menu → [NETWORK SETUP] and the setting of “[E-mail setup] page” (x page 139) in the web control screen to the factory default settings.[LOGO IMAGE] Deletes the image registered in [USER LOGO].5) Press the button.6) When the confirmation screen is displayed, press qw to select [OK], and press the button.Notef The following settings are not initialized even if [ALL USER DATA] is executed.g The [DISPLAY OPTION] menu → [UNIFORMITY]g The [PROJECTOR SETUP] menu → [ECO MANAGEMENT] → [STANDBY MODE][SERVICE PASSWORD]This function is used by a service person.
