Panasonic PT-RZ570 Operating Instructions Manual

Also see for PT-RZ570: Operating instructions

Contents

Panasonic PT-RZ570 Operating Instructions Manual Manual pdf 47 page image

Chapter 3 Basic Operations — ProjectingENGLISH - 47ProjectingCheck the external device connection (x page 34) and the power cord connection (x page 40), and turn onthe power (x page 41) to start projection. Select the image to project, and adjust appearance of the projectedimage.Selecting the input signalRemote control Control panelThe input of the image to project can be switched. Method to switch the input is as follows.f Press the input selection button on the remote control and directly specify the input to project.f Press the button on the control panel to display the input selection screen, and select theinput to project from the list.Switching the input directly with the remote controlThe input for projection can be switched by directly specifying it with the input selection button on the remotecontrol.1) Press the input selection button (, , , ,

Switches the input to HDMI1.The image of the signal input to the terminal is projected. Switches the input to HDMI2.The image of the signal input to the terminal is projected. Switches the input to DIGITAL LINK.The image of the signal input to the terminal is projected.Switches the input to COMPUTER1 or COMPUTER2.Switches to the other input when one input has already been selected. The image of the signal inputto the terminal or the terminal is projected.

Switches the input to VIDEO.The image of the signal input to the

Switches the input to DVI-D.The image of the signal input to the terminal is projected.Attentionf Images may not be projected properly depending on the external device, or the Blu-ray disc or DVD disc, to be played back.Set the [PICTURE] menu → [SYSTEM SELECTOR].f Confirm the aspect ratio of the projection screen and the image, and switch to an optimum aspect ratio from the [POSITION] menu →[ASPECT].Notef When the optional DIGITAL LINK output supported device (Model No.: ET-YFB100G, ET-YFB200G) is connected to the LAN> terminal, the input on the DIGITAL LINK output supported device changes each time the button is pressed. The inputcan also be changed using the RS-232C control command.For twisted-pair-cable transmitters of other manufacturers, switch the input on the projector to DIGITAL LINK, and then switch the input onthe twisted-pair-cable transmitter.f Set the [DISPLAY OPTION] menu → [COMPUTER IN/OUT] → [INPUT SETTING] in accordance with the signal input to the IN> terminal.f Set the [DISPLAY OPTION] menu → [COMPUTER IN/OUT] → [COMPUTER2 SELECT] to [COMPUTER2 IN] when a signal is to be input tothe terminal.