Chapter 4 Settings — [PICTURE] menuENGLISH - 65Operation Adjustment Range of adjustmentPress w. Brightness of the white part gets stronger. 0 - +10Press q. The image becomes more natural.[GAMMA]You can switch gamma mode.1) Press as to select [GAMMA].2) Press qw or the button.f The [GAMMA] individual adjustment screen is displayed.3) Press qw to switch the item.f The items will switch each time you press the button.[DEFAULT] Factory default setting.[1.8]Set so that images become as you like.[2.0][2.2]Notef In the following conditions, the [DEFAULT] setting is disabled even when it is selected, and the same gamma mode as when [2.2] is set isapplied.g When the [ADVANCED MENU] menu → [EDGE BLENDING] is set to anything other than [OFF]g When the levels of [WHITE], [RED], [GREEN], and [BLUE] are adjusted from the [DISPLAY OPTION] menu → [UNIFORMITY]g When the [DISPLAY OPTION] menu → [UNIFORMITY] → [PC CORRECTION] is set to [ON][DAYLIGHT VIEW]You can correct the image to the optimal vividness even if it is projected under a bright light.1) Press as to select [DAYLIGHT VIEW].2) Press qw or the button.f The [DAYLIGHT VIEW] individual adjustment screen is displayed.3) Press qw to switch the item.f The items will switch each time you press the button.[AUTO] Detects the brightness of the installed environment by the luminance sensor, and automaticallycorrects the vividness of the image.[OFF] No correction.[1] Corrects the image to weaken vividness.[2] Corrects the image to medium vividness.[3] Corrects the image to high vividness.Notef [AUTO] cannot be selected when the [ADVANCED MENU] menu → [EDGE BLENDING] is set to [ON] or [USER].f [AUTO] cannot be selected when the [PROJECTOR SETUP] menu → [FRONT/REAR] of [PROJECTION METHOD] is set to [REAR].f The luminance may not be detected correctly when an object is placed on top of the projector, blocking the luminance sensor. In such acase, this function may not operate properly even if it is set to [AUTO].f The factory default setting is [OFF] when the [PICTURE] menu → [PICTURE MODE] is set to [NATURAL], [REC709], or [DICOM SIM.]. Inthis case, [AUTO] cannot be selected.[SHARPNESS]You can adjust the sharpness of the projected image.1) Press as to select [SHARPNESS].2) Press qw or the button.f The [SHARPNESS] individual adjustment screen is displayed.3) Press qw to adjust the level.
