Panasonic PT-RZ570 Operating Instructions Manual

Also see for PT-RZ570: Operating instructions

Contents

Panasonic PT-RZ570 Operating Instructions Manual Manual pdf 115 page image

Chapter 4 Settings — [SIGNAL LIST] menuENGLISH - 115[SIGNAL LIST] menuOn the menu screen, select [SIGNAL LIST] from the main menu.Refer to “Navigating through the menu” (x page 57) for the operation of the menu screen.r Registered signal detailsA1 (1-2)When the address number (A1, A2, ... L7, L8) signal is registeredSub memory numberMemory number:f A name can be set for each sub memory (x page 117).Registering new signalsAfter a new signal is input and the button on the remote control or the control panel is pressed, theregistration is completed and the [MAIN MENU] screen is displayed.Notef Up to 96 signals, including sub memories, can be registered to the projector.f There are 12 pages (eight memories of A through L, with eight memories possible on each page) for memory numbers, and the signal isregistered to the lowest number that is available. If there is no available memory number it will be overwritten from the oldest signal.f The name to be registered is automatically determined by the input signal.f If a menu is being displayed, the new signals will be registered at the instant they are input.Renaming the registered signalRegistered signals can be renamed.1) Press asqw to select the signal of which name is to be changed.2) Press the button.f The [REGISTERED SIGNAL STATUS] screen is displayed.f The memory number, input terminal, input signal name, frequency, synch polarity, etc., are displayed.f Press the button to return to the [SIGNAL LIST] screen.3) Press the button.f The [REGISTERED SIGNAL SETUP] screen is displayed.4) Press as to select [SIGNAL NAME CHANGE].5) Press the button.f The [SIGNAL NAME CHANGE] screen is displayed.6) Press asqw to select the text, and press the button to enter the text.7) After the name is changed, press asqw to select [OK], and press the button.f The registration is completed and the [REGISTERED SIGNAL SETUP] screen returns.f When pressing asqw to select [CANCEL] and pressing the button, the changed signal namewill not be registered and an automatically registered signal name will be used.Deleting the registered signalRegistered signals can be deleted.1) Press asqw to select the signal to delete.2) Press the button on the remote control.f The [REGISTERED SIGNAL DELETE] screen is displayed.f To cancel the deletion, press the button to return to the [REGISTERED SIGNAL LIST] screen.3) Press the button.f The selected signal will be deleted.