Chapter 2 Getting Started — ConnectingENGLISH - 35 terminal pin assignments and signal namesOutside view Pin No. Signal name Pin No. Signal name(17)(24)(16) (9)(1)(8)(1) T.M.D.S data 2- (13) ―(2) T.M.D.S data 2+ (14) +5 V(3) T.M.D.S data 2/4 shield (15) GND(4) ― (16) Hot plug detection(5) ― (17) T.M.D.S data 0-(6) DDC clock (18) T.M.D.S data 0+(7) DDC data (19) T.M.D.S data 0/5 shield(8) ― (20) ―(9) T.M.D.S data 1- (21) ―(10) T.M.D.S data 1+ (22) T.M.D.S clock shield(11) T.M.D.S data 1/3 shield (23) T.M.D.S clock+(12) ― (24) T.M.D.S clock-Connecting example: AV equipmentBlu-ray disc playerVCR (with built-in TBC)DVD player with HDMI terminal (HDCP)Audio deviceDVD playerS-video cable (commerciallyavailable)D-SUB - S Video conversion cable(Optional (Model No.: ET-ADSV))Attentionf Be sure to use one of the following when connecting a VCR.g Use a VCR with built-in time base corrector (TBC).g Use a time base corrector (TBC) between the projector and the VCR.f The image may be disrupted when nonstandard burst signal is connected. In such a case, connect the time base corrector (TBC) betweenthe projector and the external devices.Notef Switching of the setting in the [DISPLAY OPTION] menu → [DVI-D IN] → [EDID SELECT] may be required depending on the connectedexternal device when DVI-D is input.f The terminal can be connected with the HDMI and DVI-D compatible devices. However, some external devices may not be ableto project images properly, such as the image not displaying.f For the HDMI cable, use an HDMI High Speed cable that conforms to the HDMI standards. If a cable that does not conform to the HDMIstandards is used, images may be interrupted or may not be projected.f The / terminals can be connected to an external device with the DVI-D terminal by using an HDMI/DVI conversioncable. However, this may not function properly for some external devices, and image may not be projected.f The projector does not support VIERA Link (HDMI).f When Y/C signal is input to the terminal using the optional D-SUB - S Video conversion cable (Model No.: ET-ADSV), itis necessary to switch the setting with the [DISPLAY OPTION] menu → [COMPUTER IN/OUT] → [INPUT SETTING].f When RGB signal or YCBCR /YPBPR signal input to the terminal is output from the terminal,it is necessary to switch the setting with the [DISPLAY OPTION] menu → [COMPUTER IN/OUT] → [COMPUTER2 SELECT].
