5-74 ICX (International) issued December 1999 ICX-40-700Chapter 5. Key Telephone Features Section 700 - Operation• If the called party’s number and name are stored in the PSD code, that information appears onthe display when you use the speed dial code.• Speed dial numbers can contain up to 24 characters. The following table reflects which keys touse.* Indicates that the digits that follow are either a feature access code or an extensionnumber. (Not needed if your System is set for Intercom Level.) See Note below.** Indicates that the digits that follow are for an outside number and the System shouldseize the next available exchange line when dialing. (Not needed if your System is setfor CO/Exchange line Level.) See Note below.*** Indicates that the enclosed digits should not be displayed during dialing. Must precedeand follow the digits that you do not want displayed. Example: MEMORY *2 555-4143MEMORY*2.Note: The System has two levels - CO/Exchange line Level Level and Intercom Level. If set atCO/Exchange line Level Level (default), you must enter the code for Intercom Level whenprogramming a feature access code or extension number for speed dialing. If the System is set atIntercom Level, you must enter the MCO Code when programming an outside number for speeddialing.System Speed DialYou can store frequently called numbers using the SSD feature. Either 80 or 800 SSD numbers can beprogrammed, depending on how the System is configured. In an 80 SSD-number system, the SSDnumbers are stored in bins 00-79. In 800 SSD-number systems, the SSD numbers are stored in bins000-799.OperationTo assign SSD numbers:To indicate. . . Enter/Press Shown on Display?Digit or character 0, 1 - 9, *, # yes (unless preceded by MEMORY * 2 -see *** below)Intercom Level * MEMORY * # noMCO Code ** MEMORY * 0 noPause REDIAL noDP - DTMF Code MEMORY * * noSSD Code MEMORY NN(N) noHyphen (-) PROG yesDisplay Number (Start /Stop) ***MEMORY * 2DTMF Conversion Afterthe Other Party AnswersMEMORY * 3(Version 3.0 or higher)Action Result1. Lift the handset or press the ON/OFF key. Intercom dial tone
