Section 700 - Operation Chapter 4. User MaintenanceICX-40-700 ICX (International) issued December 1999 4-21Set Send Text MessagesVersion 3.0 or HigherDescriptionYou can send a text message to a key telephone with a display when you are sending call waitingsignal (Auto camp-on or manual camp-on). This menu item specifies the text messages that may besent.OperationTo set Send Text Messages using either a large-display or small-display phone:Action Result1. If not already in User Maintenance mode, enter User Main-tenance mode. (See “To enter User Maintenance mode:” onpage 4-3.)81-User MAINT displays2. At the 81 level, enter 11.3. Press the HOLD key. 8111-Text Message displays4. Enter 0.5. Press the HOLD key. 8111-0:Send Message displays6. Press the HOLD key. Enter Msg # displays7. Enter the Message number (0-9).8. Press the HOLD key. A B C D E F Xdisplays (where X = Send Text Messagenumber)9. Enter the Text Message (up to 15 characters):• If using a large-display phone, press the soft key nextto the desired row of letters. (See Example 1 on page4-17.)• If using a small-display phone press the appropriateone-touch key. (See Example 2 on page 4-18.)Note: Press the FL/R key to clear any existing data.10. Use the bottom row of FF keys to select a single letter.• See Example 1. Large-display phone on page 4-17.• See Example 2. Small-display phone on page 4-18.Notes:• Press the * key to erase a single entry.• Press the # key to enter a space.11. Repeat steps 9-10 as many times as necessary to enter thedesired Text Message.Note: Press the FL/R key to clear the entire entry.12. Press the HOLD key to store the entry. Next message number displays
