4-14 ICX (International) issued December 1999 ICX-40-700Chapter 4. User Maintenance Section 700 - OperationSet Mode ScheduleDescription(For a description of Automatic Day/Night System Mode, see “Automatic Day/Night Mode” on page3-21.)You can set the System to automatically enter None, Day 1, Day 2, Night, Night (1), or Night (2)modes based upon mode patterns. You can define up to 3 patterns with up to 5 modes for each day.(This menu allows the setting of the patterns.)OperationTo set the Mode Schedule:11. Press the MEMORY key to exit the entry mode. MSGID - EXT Number displays12. To return to the top menu level (81), press the PROG key.OR...To exit the User Maintenance mode, press the ON/OFFkey.81-User MAINT displaysOR...ON/OFF LED goes offAction Result1. If not already in User Maintenance mode, enter User Main-tenance mode. (See “To enter User Maintenance mode:” onpage 4-3.)81-User MAINT displays2. At the 81 level, enter 07.3. Press the HOLD key. 8107-System Mode displays4. Press the HOLD key. 0-Mode Schedule displays5. Press the HOLD key. 000 :HHMMPTN 1-1 Start T displays6. Enter the start time in hours (two characters) and minutes(two characters) for the Pattern 1 - first mode.Note: To clear an entry or existing data, press the FL/Rkey.7. Press the HOLD key. 001 :PTN 1-1 Mode displays8. Enter the desired mode for Pattern 1 - first (0 - None, 1 -Day 1, 2 - Day 2, 3 - Night, 4 - Night (1), 5 - Night (2)).Note: To clear an entry or existing data, press the FL/Rkey.9. Press the HOLD key to store the entry. Next pattern mode displaysAction Result
