9-8Operation Display Pendant99.8 Special Command DisplayIn this display, you can transmit selected commands to the controller.The selection of the commands you can choose from depends on the main operation mode. They can be switchedby pressing the f2/f6 SEL key.When you select a command from the list and press the Return key, it is transmitted to the controller and theresult of the command is shown in the display. By pressing the f2/f6 SEL key, it is switched to the commandcontent display.In the previous example of display 2), command ìtoMode15î is selected. When you press the Return key, thiscommand is transmitted to the controller and the result of the command is displayed in display 3).Command DisplayAbort CMD:AbortError reset CMD:RstErrServo ON CMD:SrvOnServo OFF CMD:SrvOffMechanical setting operation start CMD:toMode15Software driver reset CMD:RstDriveMotor type request CMD:MotorTypeROM version request CMD:ROM VersionError status request/refresh CMD:RefErrSts1) Initial display2) Displaying command3) Displaying command resultCCCC ssssttttSSSSrrrrrrrrEEEEffffeeeeRRRR::::DDDDMMMMPPPP////NNNNLLLLEEEESSSS----ccccppppSSSS----NNNN rrrroooorrrrrrrrEEEEooooPPPP////NNNNLLLLEEEESSSS----ccccppppSSSS----Command display areaFunction key contentdisplay areaCommand resultdisplay areaFunction key contentdisplay areaCMD:Abort-Spc- SEL N/PCMD:toMode15-Spc- SEL N/PMode15 Exec!-Spc- SEL N/Pf2 SEL: Switches command (positive).f3 N: To the next displayf6 SEL: Switches command (opposite).f7 P: To the previous displayReturn key: Transmits the selected command to the driver.
