4-34.2 Preoperation check(1) Items to prepare• Motor unit/driver/sensor/DC power supply• PC utility (floppy disk)• Level block for fixing the motor• PC (with Windows 95/98/98SE/Me/NT4.0/2000 installed)• Various cables(2) Installation and WiringMotor part(main body)DrvGIItypedriverSensorPC(prepared by customers)1) Level block(prepared by customers)4) Motor cableCM0300M(R) -ooo7) RS232C cable(dedicated)CP7576(77)S-0203) Power supply lineLevel blockCN 2TB 1TB 224V DCpower supply(prepared by customers)6) Sensor wiring(prepared bycustomers)5) Encoder cableCE7800M(R)-oooPC utility (software)CN 1PositioningcontrollerCN 4(3) Items to be checked Check1) Is the main body fixed on the level block? "2) Is the motor not interfering with peripherals? "3) Is the power supply line wired properly? (LINE, GND) "4) Is the motor cable wired properly? (VA, VB, VC. GND) "5) Is the encoder cable wired properly? "6) Is the sensor wired properly? "(Home position, OT sensor: driver (or positioning controller))7) Is the RS232C cable wired properly? "8) Is RS-232C operation enabled? "(Is bit 2 of PSW1 is on?)9) Is the wiring with the positioning controller done properly? "(See a connection example on the following page.)4
