Chapter 8: Device Management1442. If Use the Following DNS Server Addresses is selected, whether ornot DHCP is selected, the addresses entered in this section is usedto connect to the DNS server.Enter the following information if the Following DNS ServerAddresses is selected. These addresses are the primary andsecondary DNS addresses used if the primary DNS serverconnection is lost due to an outage.a. Primary DNS Server IP Addressb. Secondary DNS Server IP Address3. When finished, click OK.Your KX II device is now network accessible.LAN Interface SettingsThe current parameter settings are identified in the Current LAN interfaceparameters field.1. Choose Device Settings > Network. The Network Settings pageopens.2. Choose the LAN Interface Speed & Duplex from the followingoptions: Autodetect (default option) 10 Mbps/Half - Both LEDs blink 10 Mbps/Full - Both LEDs blink 100 Mbps/Half - Yellow LED blinks 100 Mbps/Full - Yellow LED blinks 1000 Mbps/Full (gigabit) - Green LED blinks Half-duplex provides for communication in both directions, butonly one direction at a time (not simultaneously). Full-duplex allows communication in both directionssimultaneously.Note: Occasionally there are problems running at 10 Mbps in eitherhalf or full duplex. If you are experiencing problems, try anotherspeed and duplex setting.See Network Speed Settings (on page 300) for more information.3. Select the Enable Automatic Failover checkbox to allow the KX II toautomatically recover its network connection using a second networkport if the active network port fails.
