Chapter 8: Device Management159Configure SNMP traps on the Event Management - Settings page, whichcan be quickly accessed by clicking the SNMP Trap Configuration link.See Configuring SNMP Traps (on page 162)for information oncreating SNMP traps and List of KX II SNMP Traps (on page 165) for alist of available KX II SNMP traps.The events that are captured once an SNMP trap is configured areselected on the Event Management - Destination page. SeeConfiguring Event Management - Destinations (on page 169).To reset to factory defaults: Click Reset To Defaults. All items on the page are set back to theirdefaults.WARNING: When using SNMP traps over UDP, it is possible for theKX II and the router that it is attached to fall out of synchronizationwhen the KX II is rebooted, preventing the reboot completed SNMPtrap from being logged.Configuring Modem SettingsTo configure modem settings:1. Click Device Settings > Modem Settings to open the Modem Settingspage.2. Select the Enable Modem checkbox. This will enable the Serial LineSpeed and Modem Init String field.3. The Serial Line Speed of the modem is set to 115200.4. Enter the initial modem string in the Modem Init String field. If themodem string is left blank, the following string is sent to the modemby default: ATZ OK AT OK.
