Appendix B: Dual Video Port Groups322Diagram keyConnection from the target's primary (first) video port tothe KX IIConnection from the target's secondary (second) videoport to the KX IIIP connection between the KX II and remote clientTarget server - configure the display settings and launchthe dual port video groupDisplay settings are the same on the remote client andtarget server (recommended)Horizontal - Primary (Left) - defined on the Port GroupManagement page in KX IISecondary (Right) - defined on the Port GroupManagement page in KX IIDual Port Video Configuration StepsStep 1: Configure the Target Server DisplayThe orientation setting configured on the device for the target mustmatch the actual configuration on the target operating system.It is recommended that the connecting client have the same screenorientation whenever possible.For information on display orientations and mouse modes, review theprevious topics in this section.Note: See your target server or operating system user documentation forexact steps on configuring display settings.To configure target server display and mouse settings:1. At the target server, configure the target server display orientation foreach video port to match the display orientation of your remote client.For example, if you are using an extended desktop orientationmoving from left-to-right across two monitors at the remote client, setthe target server display orientation to the same.2. Ensure that your target server's video has already been set to asupported resolution and refresh rate. See Supported TargetServer Video Resolutions (see "Supported Video Resolutions"on page 313,http://www.raritan.com/help/kx-iii/v3.0.0/en/index.htm#32872)
