Chapter 8: Device Management171Note: If either of these checkboxes is selected and power input is notactually connected, the power LED at the front of the unit turns red.To turn off the automatic detection: Deselect the checkbox for the appropriate power supply.To reset to factory defaults: Click Reset To Defaults.Note: The KX II does NOT report power supply status toCommandCenter. Dominion I (generation 1), however, does reportpower supply status to CommandCenter.Configuring PortsThe Port Configuration page displays a list of the KX II ports.Ports connected to KVM target servers (blades and standard servers)and rack PDUs (power strips) are displayed in blue, and can be edited.Ports with no CIM connected or with a blank CIM name, a default portname of Dominion-KX2_Port#is assigned, where Port# is the number ofthe KX II physical port.When a port's status is down, Not Available is displayed as its status. Aport may be down when the port's CIM is removed or powered down.Note: For blade chassis, the blade chassis name can be changed but itsblade slot names cannot be changed.After you have renamed the port, use the Reset to Default function atany time to return it to its default port name.When you reset a port name to its default, any existing powerassociations are removed and, if the port is a part of a port group, it isremoved from the group.To access a port configuration:1. Choose Device Settings > Port Configuration. The Port ConfigurationPage opens.This page is initially displayed in port number order, but can besorted on any of the fields by clicking on the column heading. Port Number - Numbered from 1 to the total number of portsavailable for the KX II device Port Name - The name assigned to the port
