20 TASCAM DR-60D2 – Names and functions of partsLeft side panels 1/L connector (XLR/TRS)These are balanced analog XLR/TRS combo jacks for microphoneand line level inputs.XLR (1: GND, 2: HOT, 3: COLD)TRS (Tip: HOT, Ring: COLD, Sleeve: GND)d 3-4 connector (φ3.5mm stereo mini jack)This TRS analog input jack can provide plug-in power.TRS (Tip: HOT, Ring: COLD, Sleeve: GND)f 2/R connector (XLR/TRS)These are balanced analog XLR/TRS combo jacks for microphoneand line level inputs.XLR (1: GND, 2: HOT, 3: COLD)TRS (Tip: HOT, Ring: COLD, Sleeve: GND)CAUTION• Confirm that phantom power is OFF before connecting a linelevel device to a 1/L connector or 2/R connector. If you connecta line level device while phantom power is being supplied, thatdevice and this unit could be damaged.• When using a condenser microphone, before connecting to anddisconnecting from a 1/L connector or 2/R connector, confirmthat the phantom power for that jack is OFF. If you connect ordisconnect a mic while phantom power is being supplied, thatmic and this unit could be damaged.• Do not connect an unbalanced dynamic mic to an XLR connectorwhen phantom power is being supplied. Doing so could damagethat mic and this unit.g CAMERA IN connector (φ3.5mm stereo mini jack)Connect to the audio output of a camera.Refer to the camera’s operation manual to identify this connectoron the camera. (See “Camera connection and attachment” onpage 39.)h REMOTE connector (φ2.5mm TRS jack)Connect a TASCAM RC-3F footswitch or TASCAM RC-10 wiredremote control (both sold separately) here to enable remotestarting and stopping of playback and other functions. (See “11 –Using the REMOTE jack” on page 89.)
