Tascam HS-2 Owner's Manual

Contents

100 TASCAM HS-2• VNC (Virtual Network Computing)You can operate the system on a computer by displayingthe screen which is displayed on this unit’s LCD on thecomputer using VNC Viewer Application.You can operate the following using a mouse on the VNCViewer Application.Left click of the mouse : Operates in the same way as touchingthe LCD of this unit.Mouse wheel click : Operates in the same way as the ENTERkey of this unit.Mouse wheel rotate : Operates in the same way as the DATAdial of this unit.M ouse wheel pressand rotate: Operates in coarse settings in the sameway as when you press and rotate theDATA dial of this unit (COARSE mode op-eration).You can perform the following operations using thecomputer keyboard with the VNC Viewer Applicationactive.F1 to F12 key : Operate in the same way as an externalkeyboard connected with this unit.See “Section 12 Other functions” Opera-tions using the computer keyboard –Key-board Operation” in the Operation Manualof this unit.HOME key : Operates in the same way as the HOMEkey of this unit and displays the HOMEscreen. Press the End key while hold-ing the HOME key to display the LOCKSETUP screen.End key : Operates in the same way as the MENUkey of this unit and displays the MENUscreen. Press the End key while hold-ing the HOME key to display the LOCKSETUP screen.PageDown : Operates in the same way as the PROJECTkey of this unit and displays the PROJ-ECT screen.Cursor 2 key : Operates in the same way as rotating theDATA dial of this unit clockwise.when editing parameter values, or scrollsthe list up when the screen shows a list.Cursor x key : Operates in the same way as rotating theDATA dial of this unit anti-clockwise.when editing parameter values, or scrollsthe list down when the screen shows a list.Character input keys : Input the characters while this unit dis-plays the keyboard screen.• Setting values necessary to connect with VNCSetting values necessary to connect VNC Viewer Appli-cation with this unit are as follows:IP Address : The IP Address of this unit is shown in IP Ad-dress on the ETHERNET page of the REMOTESETUP screen.Password : The default password is “HS-2”.Distinguishes between capital letters and smallletters.You can change the password using thePassword [Change ] button on theETHERNET page of the REMOTE SETUPscreen.NOTE• Only one active VNC connection is allowed.• If EXTERNAL Control" on the LOCK SETUP screenis set to LOCK, display in the VNC Viewer Applicationis possible, but mouse and keyboard interaction isignored.• If you change any setting on the ETHERNET page onthe REMOTE SETUP screen while a VNC connection isactive, that VNC session will be disconnected.• Please consult with TASCAM Customer Support forinformation about VNC Viewer Applications that havebeen tested with this unit.• VNC Viewer Application response will slow down whena file is being transferred by FTP, or at high system Fsrates (88.2kHz/96kHz/176.4kHz/192kHz)Audio Signal Input and Outputsettings (AUDIO I/O)Input and Output Audio signal settings can be changedhere.The AUDIO I/O screen has two pages: INPUT andOUTPUT.Touch the tabs at the bottom of the screen to open thecorresponding page.INPUT pageMake input settings on this page.INPUT SOURCEYou can set the input source. Select analog XLR input,analog RCA input or digital input.Setting buttons: Analog XLR (Default), Analog RCA,Digital X (“X” stands for either AES/EBU or S/PDIF)DIGITAL SOURCEYou can select the digital input source.Setting buttons: AES/EBU (Default), S/DIFFs CONVERTTurn the sampling rate converter ON or OFF (default) foreach pair of inputs.10–Internal settings