90 TASCAM HS-2• If the space on either of the media storage devices runsout or an error occurs during recording with Mirrorset, recording to the media storage device with nospace remaining or to the media storage device onwhich an error has occurred will stop. Recording of thecurrent file to the other media storage device will stop.However, recording to the next take as a new file willstart.Then, the message and media storage device remainingspace display button will be shown as follows:1 If either of the media storage devices has run out ofspaceMedia storage device remaining space button2 If a recording error has occurred on either of themedia storage devicesMedia storage device remaining space buttonFILE FORMAT pageMake settings related to the file format.Bit LengthSet the quantization bit rate for recording files using thefollowing buttons.Setting buttons: 16bit (default), 24bitMax File SizeSet the maximum size for recording files using thefollowing buttons.Setting buttons: 640MB, 1GB, 2GB (default)Pause ModeSet whether or not to divide files when a recording ispaused using the following buttons.Setting buttons: SPLIT (default), NO SPLITOPTIONS pageMake settings related to the pre-recording and automarkers.PreREC TimeTurn this function ON or OFF and set the length ofpre-recording time. (Default: OFF)When PreREC Time is ON, the signal input duringrecording standby is captured by the built-in memory forthe set amount of time, allowing a maximum of 5 secondsto be recorded before recording is started manually.To set the pre–recording time, touch the knob, and adjustthe value using the DATA dial.Setting range: 1–5 seconds (default: 2 seconds)Auto MarkerMake settings related to auto markers.Audio Over:Use this to add markers when the set audio level isexceeded.Turn this function ON or OFF and set the detectionlevel. (Default: OFF)To set the detection level, touch the knob, andadjust the value using the DATA dial.Setting options: –0.20dB (default), –0.17dB,–0.13dB, –0.10dB, –0.06dB, –0.03dBSettings made here are reflected in the OverLevel setting on the METER SETUP screen.Time Interval:Use this to add marks at fixed time intervals. Turnthis function ON or OFF and set the time interval.(Default: OFF)To set the time, touch the knob, and adjust thevalue using the DATA dial. The range of settingvalues is 1–10 minutes (default: 5 minutes).Sync Unlock:Use this to add a mark when synchronization withthe master clock is lost. Turn this function ON orOFF. (Default: OFF)PRE / REC / END:Marks are attached automatically on the PRERECstart point/ recording start point/ recording endpoint. Set the ON / OFF status of the functions.(Default: OFF)10–Internal settings