TASCAM HS-2 97Video ResolveWhen slaving this unit to a VCR, video sync signals mightbe used instead of word sync signals for the commonstandard clock. In the same way as with word syncsignals, you can select whether the video clock is followed(synchronizing the beginning of time code frames withvideo signal frame edges) or it is independent from theframe clock.This must be turned ON to accurately control this unit froma video editor.ON (default): Time code frame edges synchronized withvideo signal frame edgesOFF: Independent from video frame clockETHERNET pagePerform settings related to the ETHERNET communication.STATUSShows the MAC Address of this unit and the current IPAddress.IP MODEThis button is to enable or disable all network activity.Setting buttons: Disable (Disabled, Default), Enable(Enabled)IP SETUPSelects how the unit's IP address is specifiedIn DHCP mode, if a DHCP server exists on the same LANnetwork as the unit, the IP address, Subnet Mask andDefault Gateway settings are automatically obtained.In the STATIC settings, IP Address, Subnet Mask andDefault Gateway must be set manually.Setting buttons: DHCP, STATIC (default)LINK SPEEDThis button affects how the link speed is determined.Setting buttons: Auto (Default. Negotiates the best possiblelink speed according to the networkenvironment.)100M (Operates with a fixed link speed of100Mbps)IP Address / Subnet Mask / Default GatewayAllows setting and display of the specified values to beused in STATIC IP address mode.Default: 0. 0. 0. 0.According to the above IP SETUP settings, the display ofthis area will change as follows:When setting DHCP When setting STATIC When touchingChanging the IP Address / Subnet Mask / DefaultGateway settingsTouch the applicable area on the ETHERNET page of theREMOTE SETUP screen to display each setting adjustmentscreen.• Numbers are three digits. (For those of two digits orless, you do not need to input 0 first.)• The first digits are selected after the screen is displayed.• Touch the first number button after entering theselection mode to set that only the numbers of thebuttons touched are input. Subsequently, the numbersare input using the number pad.• Touch the dot (“.”) button to move the selection to thenext number.Example)W h e n d i s -played on thescreen192. 168. 1. 1Input 1234 234. 168. 1. 1 (The first “1” is pushedforward.)Input “ . ” 192. 168. 1. 110–Internal settings
