TASCAM HS-2 91NOTEAudio Over occurs when the level exceeds themaximum level (full scale) minus the value set by theuser. (In the example above, this would be when the levelexceeds the maximum level minus 0.20 dB.)NOTEThe PRE/REC/END auto marker is only recorded intotakes in take mode, and does not appear on the timelinein timeline mode.NOTEAfter an Audio Over or Sync Unlock auto marker hasbeen placed, the same type of mark is not repeated untilat least 10 seconds has passed.Playback settings (PLAY SETUP)Use this screen to make settings related to playback.GENERAL pageMake various settings related to the playback mode onthis page.Play ModeSet how the playback of takes and entries is handledusing the following buttons. This setting affects all modesexcept timeline mode.One Take button (default):Only the currently selected take or playback isplayed back.All Take button:All the takes in the currently loaded session or allthe entries in the playlist are played back.Repeat ModeTurn repeat playback ON and OFF (default).CONTROL pageMake various settings related to the playback functionson this page.Auto CueTurn the auto cue function ON or OFF (default). If auto cueis ON, whenever a take is changed or loaded, the unit willenter playback standby at the point where sound firststarts in the take. When Play Mode is set to One Takeand no sound is detected before the end of the take, theunit stops at the start of the take. When Play Mode is setto All Take and no sound is detected before the end ofthe take, the unit continues detection in the next take.This setting affects all modes except timeline mode.To set the auto cue start point detection level, touch theknob area and use the DATA dial to change the value.Options: –72dB, –66dB, –60dB, –54dB (default), –48dB,–42dB, –36dB, –30dB, –24dB10–Internal settings
