Terex Genie SX-105 XC Service And Repair Manual

Also see for Genie SX-105 XC: Maintenance manual Maintenance manual Maintenance manual Operator's manual supplement Operator's manual

Service and Repair Manual May 2020Boom Components68 SX™-105 XC™ • SX™-125 XC™ Part No. 1271700GT20 Secure the number 2 and number 3 boomstogether at the platform end with a chain orstrap to prevent them from moving.21 Install the boom extension cylinder assemblyinto the boom.Note: Before lowering the extension cylinder intothe saddles of the number 1 boom tube, wrap theboom retract cables around the pulleys.22 Remove the chain or strap from the platformend of the number 2 and number 3 boomtubes.23 Adjust the boom extend/retract cables. Referto Repair Procedure, How to Adjust the BoomExtend and Retract Cables.4-6Primary Boom Angle SensorThe primary boom angle sensor is used to limit theangle of the primary boom relative to the angle ofthe turntable and gravity.How to Calibrate the PrimaryBoom Angle SensorNote: If the angle sensor is replaced, both thesensor and magnet must be replaced as a set.Note: Perform this procedure with the machine ona firm, level surface and in the stowed positionwith the axles extended.Note: The turntable level sensor must becalibrated prior to calibrating the primary boom.Note: RSB1AO and RSB1AS are calibrated at thesame time.Note: Primary boom angle must be calibratedbefore calibrating boom length.Note: If the calibration flags between SCON andTCON do not agree after calibration, a crosscheckfault is generated and recorded and the affectedboom function is inhibited.Note: A digital level will be required to perform thisprocedure.Note: A kit is available through Genie ProductSupport (Genie part number 58351). This kitincludes a digital level with a magnetic base andcable harnesses.