LJ SERIES 2D EMULATION1-sided/2-sidedPurpose The 4213 can print on one side (1-sided) or both sides (2-sided)of a page.Syntax E &l#SHex 1B 26 6C # 53Dec 27 38 108 # 83where # = 0 is 1-sided# = 1 is 2-sided, long-edge binding# = 2 is 2-sided, short-edge binding.2-sided printing is not supported in the LJ Series 2D emulationwhen the manual bypass feature is used.Left Offset RegistrationPurpose This command specifies the position of the logical page acrossthe width (short side) of the physical page.Syntax E &l#UHex 1B 26 6C # 55Dec 27 38 108 # 85where # is a positive or negative number expressed indecipoints (1/720th inch) and valid up to four decimal places. Apositive value moves the logical page to the right along thewidth of the physical page except on the back side of sheetsprinted in long-edge-binding 2-sided mode, where the logicalpage moves to the left. A negative value moves the logical pageto the left, except on the back side of sheets printed in long-edge-binding 2-sided mode, where it moves to the right.Notes • Page orientation has no effect on this command.• The value # represents an absolute move in relation to thedefault position of the logical page and not the currentposition.• Positioning the logical page outside the printable area maycause loss of data.XEROX 4213 LASER PRINTER PROGRAMMER REFERENCE 3-15
