TROUBLESHOOTINGprograms, you must reboot without the PSFAX command in yourAUTOEXEC.BAT file to remove PSFAX.COM from memory.PSFAX encountered an error releasing its memory segment whileunloading.The fax software was unable to unload. To unload, you will haveto reboot.PSFAX is unloaded.Unrecognized command:The PSFAX command line switches are:/b use BIOS level data capture only/e release environment space when loading PSFAX/h show this help screen/u unload the resident PSFAX/K ENABLE FIX FOR KEYBOARD CTRL-LOCKThe message indicates you tried to use a command line switchthat PSFAX,COM does not recognize. Only the above switchesare recognized.PSFAX cannot locate the home directory. You can put the PSFAXdirectory in your PATH statement, or use the SET PSFAX commandbefore loading PSFAX to solve this problem. For example:SET PSFAX = C:\PSFAXPSFAXPSFAX can’t load because the configuration file PSFAX.CFG ismissing in the PSFAX directory. You can run INSTALL to createa new PSFAX.CGF file.There is an error in the configuration file PSFAX.CFG at theXXX line.Indicates a problem with the configuration file created when youran the install program. Try running the install program againfrom the floppy to create a new .CFG file.Could not find PSFAX Queue Control directoryPop-up menu is enabled; press [the pop-up key] to pop upGroup and delayed transmissions enabled.Messages for PSFAXQ.COM programFax Queue did not load.Fax Queue is already resident.Fax Queue requires DOS version 2.0 or later.Fax Queue cannot load, because the printer port does notexist.Indicates you specified a printer port when you ran the installprogram that does not exist on your system.Fax Queue cannot load, because PrintCache is not alreadyloaded.Indicates you chose PrintCache as your printer port when you ranthe install program, but that PrintCache was not loaded whenyou tried to load PSFAXQ.COM.Beginning to unload Fax Queue...Fax Queue is not currently loaded.5-2 XEROX MRP FAMILY FAX MODEM FOR MS-DOS OPERATOR GUIDE