Error Messages and Codes 3-19Jam ErrorsJam at Fuser: Jam F■ Reseat the Fuser.■ Remove the Fuser and check for any obstructions, media or debris.■ Cycle printer power.■ If the problem persists, follow the procedure below.WarningTo avoid the potential of electric shock, ensure the power to the printer is offand the power cord is disconnected from the wall outlet prior to performingStep 2 of the following troubleshooting procedure..Troubleshooting ReferenceApplicable Parts Wiring and Plug/Jack Map ReferencesFuser, PL 8.1.1 “Drive Section” on page 10-18Exit Sensor/Actuator, PL 8.1.7 “Fuser Assembly” on page 10-21Motor Driver Board, PL 12.1.12 “Map 1” on page 10-6Troubleshooting ProcedureSteps Actions and Questions Yes No1 Check the following for evidence of fault ordamage:Exit Actuator & Sensor, PL 8.1.7Fuser Assembly, PL 8.1.1Front Cover, PL 1.1.2Chute Assembly In, PL 5.1.1Transfer Roller, PL 8.1.12Imaging Unit, PL 9.1.3Replace thepart(s) concerned.Go to Step 2.2 Remove the Fuser and check for broken orbent pins.Replace the partsconcerned.Go to Step 3.3 Reinstall the Fuser.Does error recur after the Fuser Assemblyhas been replaced?Go to Step 4. Complete.4 Use service diagnostics to test the ExitSensor.Does the sensor function correctly?Go to Step 9. Replace theFuser Assembly.Go to Step 5.5 Does error recur after the Fuser is replaced Go to Step 6. Complete.manuals4you.commanuals4you.com
