Error Messages and Codes 3-3Servicing InstructionsThe Service Flowchart below is an overview of the path a service technician shouldtake when servicing the printer and printer optional equipment.Step 1 - Identify the Problem1. Verify the reported problem does exist. Verify failure symptoms/behavior/noiseswith cusotmer/end user.2. Check for any error codes and write them down.3. Print normal customer prints and service test prints.4. Make note of any print quality problems in the test prints.5. Make note of any mechanical or electrical abnormalities present.6. Make note of any unusual noise or smell coming from the printer.7. Print a Printer Status Page, if the printer is able to print.8. View the fault history under the Service Tools Menu9. Verify the AC input power supply is within proper specifications by measuring thevoltage at the electric outlet while the printer is running.Step 2 - Inspect and Clean the Printer1. Switch OFF printer power.2. Disconnect the AC power cord from the wall outlet.3. Verify the power cord is free from damage and is connected properly.4. Remove the Imaging Unit and protect it from light.5. Inspect the printer interior and remove any foreign matter such as paper clips,staples, pieces of paper, dust or loose toner.■ Do not use solvents or chemical cleaners to clean the printer interior.■ Do not use any type of oil or lubricant on printer parts.■ Use only an approved toner vacuum.6. Clean all rubber rollers with a lint-free cloth, dampened slightly with cold water.7. Inspect the interior of the printer for damaged wires, loose connections, tonerleakage, and damaged or obviously worn parts.8. If a toner cartridge appears obviously damaged or empty, replace with a new one.Step 3 - Find the Cause of the Problem1. Use the Error Messages and Codes troubleshooting procedures to find the causeof the problem.2. Use Diagnostics to check printer and optional components.3. Use the Wiring Diagrams and Plug/Jack Locator to locate test points.4. Take voltage readings at various test points as instructed in the appropriatetroubleshooting procedure.5. Use the "Print Engine Test Print" on page 5-9, to isolate problems to the Engine orthe Image Processor Board.Step 4 - Correct the Problem1. Use the Parts List to locate a part number.2. Use the Disassembly Procedures to replace the part.Step 5 - Final Check1. Test the printer to be sure you have corrected the initial problem and verify thereare no additional problems present.manuals4you.commanuals4you.com
