Error Messages and Codes 3-41Install or Reseat Fuser■ Ensure that the Fuser is fully seated.■ Ensure that the Fuser latches are in the fully latched position.■ Cycle printer power.■ If the problem persists, follow the procedure below.WarningTo avoid the potential of electric shock, ensure the power to the printer is offand the power cord is disconnected from the wall outlet prior to performingStep 2 in the following troubleshooting procedure..Troubleshooting Reference TableApplicable Parts Wiring and Plug/Jack Map ReferencesFuser Harness (FSR 4), PL 5.1.9 “Fuser Assembly” on page 10-21Troubleshooting Procedure TableSteps Actions and Questions Yes No1 Cycle power to the printer.Does the error recur?Go to Step 2. Complete2 Check the Fuser Assembly for fault ordamage.Replace the FuserAssembly,PL 8.1.1Power cycle theprinter afterreplacing the Fuser.Go to Step 3.3 Does the error recur after replacing theFuser Assembly?Go to Step 4. Complete4 Check the Fuser Harness (FSR4) forcontinuity.See “Fuser Assembly” on page 10-21.Go to Step 5. Replace theFuser Harness,FSR 4 PL 5.1.9.5 Check theFRONT 1A Harness forcontinuity.See “Fuser Assembly” on page 10-21.Replace the EngineControl Board,page 8-107.Replace theFRONT 1AHarnessAssembly,PL 13.1.7.manuals4you.commanuals4you.com
