3.6 Device-specific Settings3.6.2 Detailed Module Settings3-293 Machine Controller Setup DEVICESet the slave model.• Link Assignment Model DetailsThe relationship between the model displayed under DEVICE and its corresponding profile isshown below.If you manually assign a link, be sure that the actual device connected to the SVC Module isthe same as the one that is displayed under DEVICE on the Link Assignment Tab Page. PROFILESet the profile to use.• Settings: Depends on the device. BYTESet the number of transmission bytes.• Settings: Depends on the profile. INPUTSet the first register address of the input area.This setting is disabled if the profile is set to Standard Servo.• Setting range: The range of the Module’s I/O registers OUTPUTSet the first register address of the output area.This setting is disabled if the profile is set to Standard Servo.• Setting range: The range of the Module’s I/O registers DEnable or disable the I/O registers.• Settings: Enable or Disable: Enabled: DisabledDeviceCommunications SpecificationsCorrespondingProfileNumber of Trans-mission BytesMinimumCommunicationsCycleMaximumCommunicationsCycleSGDV−∗∗∗∗2∗∗ Standard Servo 48 125 μs 4 msJAPMC-MC2320-E Standard I/O 16, 32, 48, 64 250 μs 32 msJEPMC-MTD2310-E Standard I/O 16 250 μs 8 msJEPMC−MTA2900−E Standard I/O 32 125 μs 8 msJEPMC−MTA2910−E Standard I/O 16 125 μs 8 msJEPMC−MTP2900−E Standard I/O 64 125 μs 8 msJEPMC−MTP2910−E Standard I/O 64 125 μs 8 msWildCard DeviceStandard Servo 48 Depends on theactual device.Depends on theactual device.Standard I/O 16, 32, 48, 64 Depends on theactual device.Depends on theactual device.
