B.2 Parameter Table372 YASKAWA ELECTRIC TOEP C710606 09B YASKAWA AC Drive V1000 Installation & Start-Up Manual◆ U: MonitorsMonitor parameters allow the user to view drive status, fault information, and otherinformation about drive operation.T1-04 Motor RatedCurrent Sets the motor rated current in amperes (A).10 to200% ofdriveratedcurrent<12> A A − 704 —T1-05 Motor BaseFrequency Sets the base frequency of the motor in Hertz (Hz). 0.0 to400.060.0Hz A A − 705 —T1-06 Number ofMotor Poles Sets the number of motor poles. 2 to 48 4 A A − 706 —T1-07 Motor BaseSpeedSets the base speed of the motor in revolutions perminute r/min (RPM).0 to240001750r/min A A − 707 —T1-11 Motor IronLossProvides the iron loss for determining the EnergySaving coefficient. The value set to E2-10 (motoriron loss) when the power is cycled. If T1-02 ischanged, an initial value valid for the selectedcapacity will be shown.0 to6553514W A − − 70B —These values differdepending on the motorcode value and motorparameter settings.<12> Default setting value is dependent on parameter o2-04, Drive/kVA Selection.<24> Values shown here are for 200 V class drives. Double the value when using a 400 V class drive.<54> The available tuning methods dpend on control mode. Select values 2 or 3 in V/f control, 0 or 2 in OLV control,and 2 for Motor 2 control.No. Name DescriptionAnalogOutputLevel UnitControlModeAddr.HexV/fOLVPMU1: Operation Status MonitorsUse U1 monitors to display the operation status of the drive.U1-01 Frequency Reference Monitors the frequency 10 V: Maxfrequency0.01Hz A A A 40U1-02 Output Frequency Displays the output voltage. Display units aredetermined by o1-03.10 V: Maxfrequency0.01Hz<27>A A A 41No. Name Description Range Def.ControlModeAddr.HexPg.V/fOLVPM
