Yamaha F200B Service Manual

Also see for F200B: Rigging guide Owner's manual Owner's manual

5-365TIP:Using an analog circuit tester is recom-mended.10. Turn the engine start switch to OFF.11. Disconnect the test leads, and theninstall the cam position sensors.12. Remove the intake manifold (STBD).See “Removing the intake manifold” (6-17).13. Remove the fuse holder 5, and then dis-connect the fuse holder coupler m.14. Remove the engine ECM, and then dis-connect the engine ECM coupler n.15. Check the wiring harness for continuity.Cam position sensor output voltage:White/Black (W/B)–Black (B)(STBD IN)White/Blue (W/L)–Black (B)(PORT EX)Position Voltageg, k More than 4.8h Less than 1.0White/Green (W/G)–Black (B)(PORT IN)Position Voltageg, k Less than 1.0h More than 4.84g h kWiring harness continuity:a Terminal 1–m Terminals 1–10 and 16–22a Terminal 2–n Terminal 1a Terminal 3–n Terminal 18b Terminal 1–n Terminal 18b Terminal 2–n Terminal 2b Terminal 3–m Terminals 1–10 and 16–22c Terminal 2–n Terminal 3c Terminal 3–n Terminal 185mn1123232 132318m 91022 21 20 19 18 17 168 7 6 5 4 3 2 1anbcEngine control system and component