3 - 18INSPADJOIL PRESSURE INSPECTION1. Check: Oil pressureChecking steps: Slightly loosen the oil pressure check bolt1. Start the engine and keep it idling until oilstarts to seep from the oil pressure checkbolt. If no oil comes out after one minute,turn the engine off so it will not seize. Check oil passages and oil pump for dam-age or leakage. Start the engine after solving the prob-lem(s) and recheck the oil pressure. Tighten the oil pressure check bolt.T R..Oil pressure check bolt:10 Nm (1.0 m • kg, 7.2 ft • lb)PILOT SCREW ADJUSTMENT1. Adjust: Pilot screw 1* For EUROPE** For CDN, ZA, AUS and NZAdjustment steps:NOTE:To optimize the fuel flow at a smaller throttleopening, each machine’s pilot screw hasbeen individually set at the factory. Beforeadjusting the pilot screw, turn it in fully andcount the number of turns. Record this num-ber as the factory-set number of turns out. Turn in the pilot screw until it is lightlyseated. Turn out the pilot screw by the factory-setnumber of turns.Pilot screw:2 turns out* 1 turn out** 1-1/8 turns out(example)OIL PRESSURE INSPECTION/PILOT SCREW ADJUSTMENT
