Yamaha pmn Owner's Manual

Also see for CinemaDSP digital RX-Z1: Owner's manual Service manual

Contents

E-105SOUND FIELDPROGRAMS EnglishSOUND FIELD PROGRAM PARAMETER EDITINGYou can enjoy good quality sound with the preset parameters. Although you do not have to change the initial settings, you can change someof the parameters to better suit the input source or your listening room.Changing parameter settingsAdjustment should be made with the remote control.11 Turn on the video monitor.22 Go to the RECEIVER control panel and press leftbutton (labeled “OSD”) repeatedly to select the fulldisplay mode.33 Go to one of the DSP control panels and select a DSPprogram you want to adjust.44 Tap ( or repeatedly) to open thePARAMETER control panel.55 Tap or to select the parameter.66 Tap or to change the parameter value.When you set the parameter to a value other than the factory-set value, an asterisk mark (*) appears by the parameter nameon the video monitor.77 Repeat steps 3 to 6 above as necessary to changeother parameters.Cautions• The available parameters may be displayed on more than oneOSD page for some of the programs. To scroll through pages,tap or .• You cannot change parameter values when “16 MEMORYGUARD” on the SET MENU is set to “ON”. If you want tochange the parameter values, set “16 MEMORY GUARD” to“OFF” (see page __). To reset some of the parameters to thefactory-set valuesSelect the parameter you want to reset. Then tap and hold oruntil the value temporarily stops at the factory-set value. Theasterisk mark (*) by the parameter name disappears on the videomonitor. To reset all of the parameters to the factory-set valuesUse “10 PARAMETER INI” on the SET MENU to reset all of theparameter values of all DSP programs within the selected group tothe factory-set values (see page __). This operation resets all of theparameter values of all DSP programs within that group to thefactory-set values.≥ 70mm SpectacleEFCT TRIM…………0dBP.INIT.DLY……13msP.ROOM SIZE……1.0S.DELAY……………23msS.ROOM SIZE……1.0P10 MOVIE THEATER 1243456* This display shows the third DSP control panel.