E-79ADVANCEDOPERATION EnglishREMOTE CONTROL FEATURESLearning commandsYou can program the remote control commands by transmitting IRsignals from your existing remote controls to the remote control’slearning eye. To do this, place the remote control and thecomponent’s remote control on a flat surface, 10 to 20 cm (4 to 8inches) apart.The following buttons can be programmed:• Control panel buttons.• Device actions.• Direct-access buttons and left/right buttons.You cannot program Home menu buttons directly. You mustprogram components via the Device menu.The remote control also offers empty control panel buttons that youcan program and label as existing buttons. They are visible only inthe Learn and Label mode and appear with or without labels(intended for a specific function). You will also see previouslydeleted buttons: you can restore them by reprogramming them oryou can reuse them for other commands. Learning control panel buttons11 Navigate to the control panel buttons you want to program.22 Switch to the Learn mode via at the bottom of the touch screen.Additional empty buttons appear: they can be programmed and labeled as existing buttons.33 Point the component’s original remote control at the remote control’s learning eye.44 Tap the control panel button you want to program.The button starts flashing.55 Press and hold the corresponding button on your component’s original remote control.If the remote control has learned the command successfully, “OK” flashes on the upper center of the touch screen. You can release thebutton you’re holding.If the remote control has not learned the command successfully, you will hear a short buzz and “FAIL” will appear on the remote controlicon.66 Program all other buttons you want and relabel them if necessary.77 Return to the Use mode via .10 to 20cm(4 to 8 inches)