Yamaha pmn Owner's Manual

Also see for CinemaDSP digital RX-Z1: Owner's manual Service manual

Contents

E-77ADVANCEDOPERATION EnglishREMOTE CONTROL FEATURESWorking with modesWhen you operate your components, the remote control is in the Use mode. For actions other than operating (like programming buttons,recording macros, adding components, and so on), you have to switch to the appropriate mode:For operating components.For learning commands from other components. *1For recording macros and setting timers.For labeling buttons and commands. * 1For adding new components.For deleting buttons, components and macros. * 1For changing the order in a menu.For defining brands using the remote control’s database. *2 Switching to another mode11 Tap at the bottom of the touch screen.The Mode menu pops up.22 Tap the mode you want to use.The label of the active mode appears on the top center of thetouch screen.You can now work in the selected mode. Hiding the Mode menuTo prevent accidental changes to the remote control interface andcommands, you can hide the Mode menu.11 Make sure the remote control is in the Use mode.22 Touch and hold the remote control icon for a fewseconds.The first setup panel appears.33 Scroll down to the second setup panel.44 Tap .The mode menu icon is crossed out.55 Tap the remote control icon.The remote control switches to the Use mode.Note• Repeat steps 1 to 5 to turn the Mode menu back on.*1: These actions cannot be made on the RECEIVER and TUNER. To make these actions, copy the RECEIVER and TUNER (see page__) and make actions on the copied one.*2: You can define brands other than YAMAHA for the RECEIVER and TUNER. However, you cannot operate this unit after defining theother brands. If you want to operate this unit, reset the RC code to “Yamaha-6” for the RECEIVER, and “Yamaha-1” for the TUNER.