E-6612 DYNAMIC RANGEUse this feature to adjust the dynamic range. This setting is effective only when this unit decodes Dolby Digital signals.Choices: MAX, STD, MINInitial setting: MAX (for both speakers and headphones)Caution• Some types of the Dolby Digital software do not support “MIN” for the dynamic range.If “MIN” is selected to play this type of software, the volume may be extremelylowered. If this problem occurs, select “MAX” or “STD”.13 SP DELAYUse this feature to adjust the delay of the center and the rear center channel sounds. This feature works when there is sound output from thecenter speakers, with a source like Dolby Digital or DTS, etc.Ideally, the center speaker and the rear center speaker should be the same distance fromthe main listening position as the left and right main speakers. However, in most homesituations, the center speaker or the rear center speaker is placed in line with the mainspeakers or the rear speakers. By delaying the sound from the center speaker and the rearcenter speaker, the apparent distance from the center speaker and the rear center speakerto the main listening position can be adjusted to make it seem the same as the distancebetween the left and right main speaker, and the left and right rear speakers to the listeningposition. Adjusting the delay time for the center speaker is especially important for givingdepth to the dialogue.11 Tap or to select “UNIT”.22 Tap or to select the unit to be used for setting.Select one from “msec”, “meters”, and “feet”.Notes• Setting items change depending on the unit chosen.• When “meters” or “feet” is selected, enter the distance from your listening positionto each speaker.33 Tap or to select the speaker for which the delay is adjusted.44 Tap or to set the delay.Tap for higher value and for lower value.SET MENU ITEMSMAX: Select the “MAX” setting for feature films.STD: Select the “STD” (Standard) setting for general use.MIN: Select the “MIN” setting for listening to sources atextremely low volume levels.MAXSTDMINMINSTDMAXDialog levelOutput levelInput level12 DYNAMIC RANGE≥ SP:“MAX STD MINHP:“MAX STD MIN13 SP DELAY≥ UNIT…………………feetMAIN L/R…10.0ftCENTER………10.0ftREAR L/R…10.0ftREAR CT………7.0ftL CCRRL RCRCRRCenter speaker imageRear center speaker image