Xinje DS2-20P4-BS manuals
DS2-20P4-BS
Table of contents
- Table Of Contents
- Table Of Contents
- Table Of Contents
- Checking Product and Part Names
- Adaptation table of servo drive and motor
- Installations
- Orientation
- Wiring
- Main circuit terminals
- Winding Terminals on Servo motor
- Communication port
- Signal terminals
- SI input signal
- Analog input circuit
- Encoder feedback signal
- Regenerative Resistor
- Use the operate panel
- Running status mode
- Monitoring Mode
- Auxiliary Function
- Change the motor type (F2-00)
- Check Alarm Information (F3-XX)
- Run the servo system
- Servo ON setting
- Overtravel Limit (P-OT & N-OT)
- Power-off Brake (BK)
- Alarm output
- Running time
- Control mode selection
- Electronic gear ratio
- Position command filter
- Positioning complete (/COIN)
- Positioning near (/NEAR)
- Position mode (internal position mode)
- Position parameters from segment 1 to 16
- Skip current signal (/ZCLAMP)
- Set segment through communication
- Analog value of rated speed
- Speed coincidence checking (/V-CMP)
- External torque limit (via analog voltage command)
- Output torque up to limit value signal
- Filter
- Input signal setting
- Speed control (pulse frequency command)
- Speed command pulse filter time
- Torque command offset autoadjustment (F1-04)
- Speed up to limit value output
- Switch the control mode
- Servo ready (/S-RDY)
- I/O signal distribution
- Default setting of input terminal
- Servo gain adjustment
- The experience of parameter adjustment
- Gain switch (G-SEL)
- Specification and dimension
- Torque-Speed Feature
- Servo motor dimensions
- Servo drives
- Servo drive dimensions
- Alarm Information
- Appendix 1 Parameter list
manualsdatabase
Your AI-powered manual search engine