Displaying and Debugging IPX 145Displaying andDebugging IPXAfter the above-mentioned configuration, use the display command in any viewto view the running of IPX and to verify the effect of the configuration.Use the reset command in user view to clear the IPX statistics.IPX ConfigurationExampleNetwork requirementsThrough an IPX network, Switch A with the node address of 000f-e20f-0000 isconnected to Switch B with the node address of 000f-e20f-0001.There is a server installed with NetWare 4.1 and assigned the network number of2. On the server, the packet encapsulation format is set to Ethernet_II. The client isa PC with the network number of 3 and the packet encapsulation format of SNAP.The server provides file service and printing service. The client accesses the file andprinting services provided by the server through the IPX network. The nodeaddress of the server is 0000-0c91-f61f.Enable the forwarding oftype 20 broadcast packetsipx netbios-propagation OptionalBy default, type 20 broadcastpackets are not forwardedTable 92 Configure IPX forwardingOperation Command DescriptionTable 93 Display and debug IPXOperation Command DescriptionDisplay the information of IPX onthe VLAN interfacedisplay ipx interface[ Vlan-interface vlan-id ]The display commandcan be executed in anyviewDisplay the IP packet statistics display ipx statisticsDisplay the IPX serviceinformation tabledisplay ipx service-table[ inactive | name name |network network |order { network | type } | typeservice-type ] [ verbose ]Display the IPX routinginformationdisplay ipx routing-table[ network [ verbose ] |protocol { default | direct | rip |static } [ inactive | verbose ] |statistics | verbose ]Clear the IPX statistics reset ipx statistics The reset commandcan be executed inuser viewClear the IPX routing tableinformationreset ipx routing-tablestatistics protocol { all | default |direct | rip | static }
