Intra-Cluster Configuration 713Intra-ClusterConfigurationn After a cluster is established, SNMP Trap is enabled when Switch 7750s join thecluster as candidate devices or leave the cluster as member devices. You can usethe undo snmp trap enable command to disable SNMP Trap.Displaying andMaintaining a ClusterAfter the configuration above, you can execute the display command to displaythe running status after the cluster configuration. You can verify the configurationeffect through checking the displayed information.Table 577 Configure a clusterOperation Command DescriptionEnter system view system-view -Enter cluster view cluster -Add a candidatedevice to a clusteradd-member[ member-number ]mac-address H-H-H [ passwordpassword ]OptionalRemove a memberdevice from theclusterdelete-member member-num OptionalReboot a specifiedmember devicereboot member { member-num| mac-address H-H-H }[ eraseflash ]OptionalReturn to system view quit -Return to user view quit -Switch between themanagement deviceview and a memberdevice viewclusterswitch-to { member-number |mac-address H-H-H |administrator }OptionalSwitch between the managementdevice view and the memberdevice viewTable 578 Display and maintain cluster configurationsOperation Command DescriptionDisplay the global NDPconfiguration (including theinterval to send NDP packetsand the holdtime)display ndp OptionalYou can execute thedisplay command inany viewDisplay the information aboutthe neighbors discovered byNDP and connected to specifiedportsdisplay ndp interface port-listDisplay the global NTDPinformationdisplay ntdpDisplay device informationcollected through NTDPdisplay ntdp device-list[ verbose ]Display state and statisticsinformation about a clusterdisplay clusterDisplay the information aboutthe candidate devices of aclusterdisplay cluster candidates[ mac-address H-H-H | verbose ]Display the information aboutthe cluster membersdisplay cluster members[ member-num | verbose ]
