388 CHAPTER 38: R OUTE CAPACITY CONFIGURATIONn The safety-value must be greater than the limit-value.Enabling/DisablingAutomatic ProtocolConnection Recoveryc CAUTION: If automatic protocol recovery is disabled, the broken OSPF or BGPconnection will not recover even when the free memory exceeds the safety value.Therefore, do not disable this function if not necessary.Displaying RouteCapacityConfigurationAfter the above configuration, you can use the display command in any view todisplay and verify the route capacity configuration.Table 315 Set the lower limit and the safety value of switch memoryOperation Command DescriptionEnter system view system-view -Set the lower limit and thesafety value of switchmemorymemory { safety safety-value |limit limit-value }*Optionalsafety-value defaults to 40and limit-value defaults to30.Table 316 Enable automatic protocol recoveryOperation Command DescriptionEnter system view system-view -Enable automaticprotocol recoverymemory auto-establishenableOptionalBy default, automatic protocolconnection recovery is enabled.Disable automaticprotocol connectionrecoverymemory auto-establishdisableOptionalPerform this configuration with caution.Table 317 Display route capacity configurationOperation Command DescriptionDisplay memory occupancy of aswitchdisplay memory [ unitunit-id ]OptionalDisplay the route capacityrelated memory setting andstate informationdisplay memory limit Optional
