RIP Configuration Example 299RIP ConfigurationExampleNetwork requirementsAs shown in Figure 70, SwitchC is connected to subnet 117.102.0.0 through anEthernet port. SwitchA and SwitchB are connected to networks 155.10.1.0 and196.38.165.0 respectively through Ethernet ports. SwitchC, SwitchA and SwitchBare interconnected through Ethernet 110.11.2.0. It is required to configure RIPcorrectly to ensure the interworking between the networks connected to SwitchC,SwitchA and SwitchB.Network diagramFigure 70 RIP configurationConfiguration proceduren Only the configuration related to RIP is listed below. Before the followingconfiguration, make sure the Ethernet link layer works normally and the IPaddresses of VLAN interfaces are configured correctly.1 Configure SwitchA:# Configure RIP.system-view[SwitchA] rip[SwitchA-rip] network 110.11.2.0[SwitchA-rip] network 155.10.1.02 Configure SwitchB:# Configure RIP.system-view[SwitchB] rip[SwitchB-rip] network 196.38.165.0[SwitchB-rip] network 110.11.2.03 Configure SwitchC:Device Interface IP address Device Interface IP addressSwitch A Vlan-int1 110.11.2.1/24 Switch B Vlan-int1 110.11.2.2/24Vlan-int2 155.10.1.1/24 Vlan-int3 196.38.165.1/24Switch C Vlan-int1 110.11.2.3/24Vlan-int4 117.102.0.1/16Switch ASwitch BSwitch CVlan-int 2EthernetVlan-int 4 Vlan-int 3Vlan-int 1
