580 CHAPTER 54: ARP CONFIGURATIONARP ConfigurationExampleBasic ARP ConfigurationExampleNetwork requirements■ Disable the ARP entry checking function.■ Enable the switch to send gratuitous ARP packets periodically.■ Set the aging time for dynamic ARP entries to 10 minutes.■ Add a static ARP entry with IP address 192.168.1.1, MAC address000f-e201-0000, and outbound port Ethernet 2/0/10 of VLAN 1.Configuration procedure system-view[SW7750] undo arp check enable[SW7750] arp gratuitous-updating enable[SW7750] arp timer aging 10[SW7750] arp static 192.168.1.1 000f-e201-0000 1 Ethernet2/0/10Table 459 Display and maintain ARP configurationOperation Command DescriptionDisplay ARP attackinformationdisplay arp attack-list You can execute the displaycommand in any view.Display ARP entries display arp [ static |dynamic | ip-address ]Display the ARP entriesmatching a specified ruledisplay arp | { begin |include | exclude } textDisplay the number limits ofARP entriesdisplay arp entry-limit[ interface-typeinterface-number ]Display the ARP entries of allports on a specified slotdisplay arp slot slot-idDisplay the ARP entries of allports in a specified VLANdisplay arp vlan vlan-idDisplay the ARP entries of aspecified interfacedisplay arp interfaceinterface-typeinterface-numberDisplay ARP packet rate limitconfiguration informationdisplay arp rate-limitDisplay the setting for ARPaging timerdisplay arp timer agingDisplay information aboutARP source suppressiondisplay arpsource-suppressionClear ARP entries reset arp [ dynamic | static |interface interface-typeinterface-number ]You can execute the resetcommand in user view.Clear the ARP attackinformationreset arp attack-list
