Displaying the System Status 855Returning from CurrentView to Lower LevelViewReturning from CurrentView to User ViewDisplaying the SystemStatusYou can use the following display commands to check the status andconfiguration information about the system. For information about protocols andports, and the associated display commands, refer to relevant sections.System DebuggingEnabling/DisablingSystem DebuggingThe Ethernet switch provides a variety of debugging functions. Most of theprotocols and features supported by the Ethernet switch are provided withcorresponding debugging functions. These debugging functions are a great helpfor you to diagnose and troubleshoot your switch system.The output of debugging information is controlled by two kinds of switches:■ Protocol debugging, which controls whether the debugging information of aprotocol is output.■ Terminal display, which controls whether the debugging information is outputto a user screen.The relation between the two switches is as follows:Table 666 Return from current view to lower level viewOperation Command DescriptionReturn from currentview to lower level viewquit This operation will result in exitingthe system if current view is userview.Table 667 Return from current view to user viewOperation Command DescriptionReturn from currentview to user viewreturn The composite key hasthe same effect with the returncommand.Table 668 System display commandsOperation Command DescriptionDisplay the currentdate and time of thesystemdisplay clock You can execute thedisplay command in anyviewDisplay the version ofthe systemdisplay versionDisplay the informationabout user terminalinterfacesdisplay users [ all ]Display the debuggingstatusdisplay debugging [ interfaceinterface-type interface-number ][ module-name ]
