Configuring Redirect 673■ When a switch is connected to a RADIUS server, if the switch does not supportthe inbound TP or outbound TP configured on the RADIUS server, the TPconfiguration will be ignored on the switch.Configuration Example ■ GigabitEthernet 2/0/1 of the switch is accessed to the 10.1.1.1/24 networksegment■ Perform TP on the packets from the 10.1.1.1/24 network segment and the rateof TP is set to 128 kbps■ The packets beyond the specified traffic are forwarded after their DSCPprecedence is marked as 56Configuration procedure: system-view[SW7750-acl-basic-2000] rule permit source 10.1.1.1 0.0.0.255[SW7750-acl-basic-2000] quit[SW7750] interface GigabitEthernet 2/0/1[SW7750-GigabitEthernet2/0/1] qos[SW7750-qosb-GigabitEthernet2/0/1] traffic-limit inbound ip-group 2000 kbps 128 exceed remark-dscp 56Configuring Redirect Refer to “Redirect” on page 663 for the introduction to redirect.ConfigurationPrerequisites■ ACL rules used for traffic identifying are defined. Refer to “Choosing ACLMode for Traffic Flows” on page 639 for defining ACL rules■ The port that the packets are redirected to is specified■ The ports that needs this configuration are specifiedConfiguration Procedureacl-rule: Applied ACL rules which can be the combination of various ACL rules.The way of combination is described in Table 541.Table 544 Configure redirectOperation Command DescriptionEnter system view system-view -Enter Ethernet port view interface interface-typeinterface-number-Enter QoS view qos -Configure redirect traffic-redirect inboundacl-rule [ system-indexsystem-index ] { cpu |interface interface-typeinterface-number }RequiredDisplay the parameters fortraffic redirectdisplay qos-interface[ interface-typeinterface-number ]traffic-redirectOptionalYou can execute the displaycommand in any view.Display all the QoS settings ofthe portdisplay qos-interface[ interface-typeinterface-number ] all