UDP-Helper Configuration Example 737UDP-HelperConfigurationExampleNetwork requirements The IP address of VLAN 1 interface is 10.110.1.1/16. The VLAN interface isconnected to the network segment 10.110.0.0/16. Configure to forward thebroadcast UDP packets whose destination UDP port number is 55 to the serverwith its IP address being 202.38.1.2/24.Network diagram Figure 188 Network diagram for UDP-Helper configurationConfiguration proceduren This example assumes that the route between the switch and the networksegment 202.38.1.0/24 is reachable.# Enable UDP-Helper. system-view[SW7750] udp-helper enable# Configure port 55 as a UDP-Helper destination port.[SW7750] udp-helper port 55# Configure the server with the IP address of 202.38.1.2 as a destination server forthe UDP broadcast packets.[SW7750] interface Vlan-interface 1[SW7750-Vlan-interface1] ip address 10.110.1.1 16[SW7750-Vlan-interface1] udp-helper server 202.38.1.2Clear the statistics aboutpackets forwarded byUDP-Helperreset udp-helper packet You can use the resetcommand in user viewTable 593 Display and Maintain UDP-HelperOperation Command DescriptionIP networkVlan- int110.110 .1.1 /16 Vlan -int1202.38.1.2/24Switch(UDP HELPER) SwitchServer
