Displaying and Maintaining VRRP 559Displaying andMaintaining VRRPAfter the above configuration, you can execute the display command in any viewto view VRRP configuration and verify the configuration effect. And in user view,you can execute the reset command to clear the VRRP statistics and execute thedebugging command to debug the VRRP.VRRP ConfigurationExampleSingle-VRRP BackupGroup ConfigurationNetwork requirementsHost A uses the VRRP virtual router comprising switch A and switch B as its defaultgateway to visit host B on the Internet.The information about the VRRP backup group is as follows:■ VRRP backup group ID: 1■ Virtual router IP address: 202.38.160.111■ Master switch: Switch A■ Backup switch: Switch B■ Preemptive mode: enabledTable 436 Display and Maintain VRRPOperation Command DescriptionDisplay the VRRPstatistics informationdisplay vrrp statistics[ interface interface-typeinterface-number [ vridvirtual-router-id ] ]You can execute the displaycommand in any view.Display the VRRPstatus informationdisplay vrrp [ interfaceinterface-type interface-number[ vrid virtual-router-id ] ]Display the detailedVRRP informationdisplay vrrp verbose[ interface interface-typeinterface-number [ vridvirtual-router-id ] ]Clear the VRRPstatistics informationreset vrrp statistics [ interfaceinterface-type interface-number[ vrid virtual-router-id ] ]You can execute the resetcommand in user view.Table 437 Network descriptionSwitchEthernet portconnecting toHost AIP address of theVLAN interfaceSwitch priority inthe backup groupPreemptivemodeLSW-A Ethernet 1/0/6 202.38.160.1/24 110 EnabledLSW-B Ethernet 1/0/5 202.38.160.2/24 100 (default) Enabled
